ICOM 200 Manuale Utente Scaricare il pdf (Pagina 11)

ICOM-200 / 201

RUN mode

If the DIP-switch “PC/Run” is in position “Run”, the program in the ICOM-

200/201 is executed immediately after a reset. Debugging is not possible in

this mode.

Program download

A program created with the Tiger software is downloaded into ICOM-200/201

through the 9-pin Sub-D connector. To download the following has to be done:

Connect a power supply 8-12 V DC (Polarity: Inner contact = minus,

outer contact = plus)

Connect ICOM-200/201 and PC with 9-pin D-Sub cable

Set DIP switch of ICOM-200/201 to PC mode

Set the reset DIP switch to „Reset“ and back to original position

Start download at the PC.

Serial port 1 / Download DB-9 plug

TXD 2

RXD 3

GND 5

Wilke Technology GmbH • 0241/918900 • http://www.wilke.de/ • [email protected] 2-3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 54 55

Nessun commento

ICOM 200 Manuale Utente Pagina 11